Program for Cyclone10GX use USB-Blaster II Download Cable

Question

I use USB-Blaster II Download Cable to program for Cyclone 10GX. But in Table 2 of datasheets USB-Blaster II does not give Vcc(TRGT) for Cyclone10GX chip. Can you give information about Vcc(TRGT) for the Cyclone10GX chip when I using the USB-Blaster II caple?

nuraiman_m_intel · Answer

Hi,

Thank you for contacting intel community.

USB Blaster is connecting to 10 pin header and the 10 pin header will be connecting to FPGA.

Refer to page 9

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr_ii_cable.pdf

Regards,

Aiman

tran_hieu_007 · Answer

Hi NurAiman! This document does not recommend Vcc connect to Chip Cyclone10GX. Can you tell me more about this!

nuraiman_m_intel · Answer

Hi,Cyclone 10 GX = As specified by VCCPGM or VCCIO  Regards,Aiman

tran_hieu_007 · Answer

Thank NurAiman for support!

Forum Discussion

Program for Cyclone10GX use USB-Blaster II Download Cable

4 Replies

Recent Discussions

Quartus 20.1 and ModelSim 20.1?

USB Blaster conflicts with other FTDI devices result in PC crash

USB Blaster not available

MAX10 DDR3 Timing

MAX10 Single end I/O low/high speed bank frequency