Forum Discussion

Occasional Contributor

5 years ago

Program for Cyclone10GX use USB-Blaster II Download Cable

I use USB-Blaster II Download Cable to program for Cyclone 10GX. But in Table 2 of datasheets USB-Blaster II does not give Vcc(TRGT) for Cyclone10GX chip. Can you give information about Vcc(TRGT) for...

NurAiman_M_Intel

Super Contributor

5 years ago

Hi,

Thank you for contacting intel community.

USB Blaster is connecting to 10 pin header and the 10 pin header will be connecting to FPGA.

Refer to page 9

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr_ii_cable.pdf

Regards,

Aiman

TRAN_HIEU_007

Occasional Contributor

5 years ago

Hi NurAiman! This document does not recommend Vcc connect to Chip Cyclone10GX. Can you tell me more about this!

Forum Discussion

Program for Cyclone10GX use USB-Blaster II Download Cable

Recent Discussions

Cyclone-V SCFIFO - adding ECC to M10K/MLAB/Auto memory

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration

JTAG Chain Broken on Agilex 7-I Dev Kit

Request for Cyclone V Pinout File Information