Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributorprogram EPCS flash
Hi everyone, I am trying to configure an EPCS4 device on a BeMicro board (cyclone 3 FPGA). Thus I have added a EPCS flash controller in the SOPC builder and configured the pins DCLK, nCEO, Data...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- Hi, Yes, I did program the .sof file using Quartus first. Can you tell me where to get more info on error 8, I've searched but haven't found anything on that.... The print screen of the error in flash programmer should be attached to my last post. Thanks for your help! --- Quote End --- Hi, marek I have encounter the same problem. How did you solve it? Could you give me some guidance? It is apprciated to send the solution to my email-box. [email protected]. Thanks!
