Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Problem on using the ADC of StraixII

I want to input a zipzac wave from a signal generator to the "ADC in "of the board and then obtain the result, beside assigning the pin to the input, how to set the ADC clock to run the ADconverter? because in the signaltap, it always display the message "waiting clock"...don't know what to do with that..

looking forward to your reply^^

1 Reply

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    17 years ago

    maybe u should check your clcok source and your trigger conditions