Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Problem between VCCINT and GND

Hello everyone im working with an EP2C20Q240C8 (Cyclone II). This FPGA is being hand soldered and I have connected the probes of my multimeter between ground and vccint while i'm soldering each pin i...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Thanks very much for your reply ironmoose. Looking for temperature issues I found another post that says that when the FPGA is unpowered VCCINT and GND have a little reistance.

alterauserforums.org/forum/showthread.php?p=8286

Thanks again, i will take into cosideration the your comment about the continuity.