Power to the transceiver block in Arria II device

Question

Hi,  I am using Arria II device and I am not using Transceiver block on my board. Is it necessary to give power to the transceiver blocks even when I am not using it.  Thanks in Advance

altera_forum · Answer

you should take a look at the Pin Connection Guidelines and the Schematic Review Worksheets:

http://www.altera.com/literature/lit-dpcg.jsp

http://www.altera.com/download/board-layout-test/schematic-review-ws/srw-index.jsp

Forum Discussion

Power to the transceiver block in Arria II device

1 Reply

Recent Discussions

DE1-SoC project compiles, but board programming fails 42% through

Compatibility and Configuration of Arria10 Devices with and without HPS

USB Blaster conflicts with other FTDI devices result in PC crash

MAX10 Single end I/O low/high speed bank frequency

Device migration about DD and DA