Forum Discussion

anvitha's avatar
anvitha
Icon for New Contributor rankNew Contributor
5 years ago

nios2 processor application booting from epcq flash

Hi ,

we have cyclone v gx based custom board.In this one we used epcq64N chip.

Here i want to boot my nios2 application project from epcq memory.

Here i am able to do booting only hardware (.sof file) image but can not the software (.hex file) image.

i am following document AN736.

Here my doubt is how to set reset vector address of nios2 processor when epcq_mem_is enabled.

please help me in this issue. please send me reference project to boot from epcq memory.

3 Replies

  • BoonBengT_Altera's avatar
    BoonBengT_Altera
    Icon for Moderator rankModerator
    5 years ago

    Hi @anvitha,

    Hope this message find you well, please do let us know if you have difficulties in getting the right support or any other clarification that we can help you with.

    Warm regards.

  • BoonBengT_Altera's avatar
    BoonBengT_Altera
    Icon for Moderator rankModerator
    5 years ago

    Hi anvitha,

    Hope this message find you well and good day, as we do not receive any response from you to the previous clarification that we have provided. Please post a response in the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you with your follow-up questions.

    Warm Regards