Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Nios tool error

Hi I am trying to run a project in NiosII Ide tool version 8.0. I am getting the following error. Using cable "USB - Blaster [USB-0]" ,device 1, instance 0x00 Pausing target processor ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

It may seem obvious, but often when I get that message, I think it's due to the FPGA not being powered properly, or one of the JTAG lines not making a good connection. I've also had USB Blasters that haven't always worked perfectly, so if you have another one, you could try switching them.