Forum Discussion
FBelsak
New Contributor
New ContributorNeed MAX10M04 pin low before configuration is done
Is there a way to make outputs low before configuration when not doing in-system programming? When I go into Quartus and open and compile my design using the option path Assignments>Device>Device an...
FvM
Super Contributor
Super ContributorHi,
the question has been asked quite often. There's no software option to achieve what you want. You need to override internal weak pull-up resistors by an external pull-down resistor, e.g. 1 - 2 k, depending on the required maximal low level.
the question has been asked quite often. There's no software option to achieve what you want. You need to override internal weak pull-up resistors by an external pull-down resistor, e.g. 1 - 2 k, depending on the required maximal low level.
