Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Max 10 ADC with Nios II

I have a Max 10 Neek board, and I am trying to get ADC values into a basic NIOS II processor program (for instance, if the ADC reading is > something, turn on an LED). The board comes with a tutoria...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hello,

We also faced similar type of issue. Could you try following?

In your Qsys system, just disconnect ADC's IRQ line connection to Nios II and check what happens. You have not written any interrupt routine. So, doing this should not affect you. Also check in reference designs. As per my knowledge, they have not connected IRQ line of ADC to Nios II.

Regards,

Bhaumik