Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

JTAG can’t find device

Hi all, I am a beginner of Altera's device. Today, When I use the JTAG mode of Quartus’ programmer to configure the device EP3C5E144, the programmer always says “Unable to scan device chain. Can...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

--- Quote Start ---

Difficult to say, with this little information. Is there a chance you could post your schematic?

TDO is high-Z in the beginning. So you should see a high on this pin, if it has a pull-up resistor.

-- Ton

--- Quote End ---

Thank you very much!!