Forum Discussion

AGofs's avatar
AGofs
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

I've upgraded Quartus ii,from Rev.10.1 to Rev.13.1. After upgrade the "Available Devices list" is an inactive. How can I make it active?

I've upgraded Quartus ii,from Rev.10.1 to Rev.13.1 . I'm opening new project with "New Project Wizard". At some stage I want to select specific device from "Select from Available devices list" opti...
sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
7 years ago

Did you install device packages during the Quartus installation? If not, download them and then run the device installer.

  • AGofs's avatar
    AGofs
    Icon for Occasional Contributor rankOccasional Contributor
    7 years ago
    I'm sure about installation of device packages during Quartus installation. I've attached two pictures to this message. You can see from first that devices are installed. In addition you can see from second picture that I cannot add any another device (Maybe because this device has already installed).
    • sstrell's avatar
      sstrell
      Icon for Super Contributor rankSuper Contributor
      7 years ago

      No pictures in your message. But it might be worth it to uninstall and reinstall Quartus and the device packages. You also may want to try a newer version of the software.

    • AGofs's avatar
      AGofs
      Icon for Occasional Contributor rankOccasional Contributor
      6 years ago
      I'm sending once again the pictures.