Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorIs the AD/DA converter Cyclone 3 starter kit compatible
Hello, I am looking for a high speed DAC and found this 14 bit 250 MSPS DAC. Here is the link: http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=73&no=360&partno=2...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- If you don't need high frequencies then any ADC/DAC with parallel or SPI interfaces can be used with a cyclone. I'm not sure you'll find a ready made HSMC card with lots of channels so you may have to make your own board. --- Quote End --- Hi Daixiwen, I must connect 10 A/D and 10 D/A channels (not high frquencies) to FPGA development kit... Can you please tell me, may I use parallel or SPI interfaces with each of the A/D and D/A channel through HSMC connector in order that conversion be parallel (not sequential)? Is there another way to connect A/D and D/A channels to FPGA development kit except HSMC connection? I haven't buy a development kit yet, but I think about Cyclone II or Cyclone III... I am a newbie at FPGA, so please help me... Your help is appreciated!
