Altera_ForumHonored Contributor16 years agohowto use LEs insted of M9K? Hi, I'm using a UART 16550 core from opencores in the SOPC builder, works very fine. It has build-in rx/tx FIFO, 16 Byte each. Quartus II uses a whole M9K-Block, which means a lot of wasted RAM. M...Show More
Altera_ForumHonored Contributor16 years agoTurn off "Auto RAM replacement" and turn on "Auto RAM to Logic Cell Conversion" too.
Recent DiscussionsHow to tell Quartus my Arria10 target system CLKUSR frequency is 100MHz?Agilex 3 PLL in Source Synchronous mode ?writing a word to cfm1 using on chip flash ip on max10MAX10 FPGA IOs not entering Tri-state (Hi-Z)To INTEL - Request for Compliance Data from your customer