How to program ultrasonic sensor ez1

Question

1- can u all can help me how to program ultrasonic ez1 using verilog code.

2- b4 this i see they use tx and uart input..

3- anyone can help me how to program using analog?

4- im newbie in fpga..plz help me

altera_forum · Answer

Assuming this is the data sheet:  http://www.maxbotix.com/documents/mb1010_datasheet.pdf  You can just read the sensor range using the UART interface.  Cheers, Dave

Forum Discussion

How to program ultrasonic sensor ez1

1 Reply

Recent Discussions

Cyclone-V SCFIFO - adding ECC to M10K/MLAB/Auto memory

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration

JTAG Chain Broken on Agilex 7-I Dev Kit

Request for Cyclone V Pinout File Information