Forum Discussion
mstef1
New Contributor
New ContributorHI, I have a board with a cyclon iv and EPCS64 but te fpga does not strt the programming cycle. I attached the schematic page and the test program I am using. please any help will be appreciated maurizio stefani
HI, I have a board with a cyclon iv fpga. I am using the AS programming mode using a EPCS64. I programmed the EPCS64 but the FPGA is not programmed. I noted: - nCONFIG signal goes low but the nSt...
AnandRaj_S_Intel
Regular Contributor
Regular ContributorHI,
Check the Recommended Operating Conditions tables
Best Regards,
Anand Raj Shankar
(This message was posted on behalf of Intel Corporation)
