Forum Discussion

AAnil3

New Contributor

5 years ago

Hello Please could you tell me typical current ratings in power rails of Cyclone V E series,ie, 1)VCC 2)VCCIO 3)VCCAUX 4)VCCPD Thanks in Advance.

EngWei_O_Intel

Frequent Contributor

5 years ago

Hi Ashad Anil

Can you refer to Table10-1 in the document for Maximum Power Supply Current Transient?

You can also refer to power analysis features below:

https://www.intel.com/content/www/us/en/programmable/support/support-resources/operation-and-testing/power/pow-powerplay.html

Thanks Eng Wei

AAnil3

New Contributor

5 years ago

Thanks I have seen this line “You may observe the current transient at VCCPD only when you do not follow the recommended power-up sequence.” So If I’m setting power sequence feature, then can I get rough estimation of currents in power rails? Best Regards Ashad

Forum Discussion

Hello Please could you tell me typical current ratings in power rails of Cyclone V E series,ie, 1)VCC 2)VCCIO 3)VCCAUX 4)VCCPD Thanks in Advance.

Recent Discussions

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration

JTAG Chain Broken on Agilex 7-I Dev Kit

Request for Cyclone V Pinout File Information

Cyclone 10 LP's Extended Industrial parts