Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Hardware needed to program EPCS device using JTAG

Dear sir, I am using Active serial mode to configure cyclone-IV E FPGA. I want to program EPCS16 device through cyclone-IV FPGA using JTAG interface. I want to know the details of hardwa...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Dear sir,

Thanks a lot for your the reply. But, i want to know the details of the cable that is connected to JTAG header.

What is the vendor part code of the cable that i should buy to program EPCS16 using JTAG interface.

Please clarify.

Regards,

Thulasi