Forum Discussion

JWall40's avatar
JWall40
Icon for New Contributor rankNew Contributor
3 years ago

Guidance on using an MCU and generic flash as an EPC1QC20 replacement

Hi, I'm looking to use a generic flash and small micro as a replacement for the EPC1QC20. Specifically using Passive serial with an SPI interface. Is there any guidance documents or example code o...
JWall40's avatar
JWall40
Icon for New Contributor rankNew Contributor
3 years ago

Hi Hareesh,

Thanks for getting back to me.

Unfortunately, The device I am trying to program is a FLEX 6000 so the generic serial flash IP is unavailable. is there any guidance on how to use a standard flash and MCU as a config device without the need to modify the existing FPGA source code?

Thanks,

Jack

  • hareesh's avatar
    hareesh
    Icon for Frequent Contributor rankFrequent Contributor
    3 years ago

    hi

    Can you please give more details on precisely what you want? I am not getting you asking about an external device or IP of FPGA details.

    some reference doc link sharing here.

    link:

    https://docs.rs-online.com/0376/0900766b800b6622.pdf

    Thanks,

    hareesh.

    • hareesh's avatar
      hareesh
      Icon for Frequent Contributor rankFrequent Contributor
      3 years ago

      Hi @JWall40 ,

      Since there are no feedback for this thread, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, someone will be right with you.

      If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 9/10 survey.

      thanks,