Forum Discussion

Manav's avatar
Manav
Icon for New Contributor rankNew Contributor
5 years ago

Gigabit Ethernet using FPGA in cyclone 5 De10 nano board

I am using the cyclone 5 DE10 nano board. Is there any way I can connect the ethernet PHY to the FPGA using the TSE IP? Can the pins be shared between the HPS and the FPGA?

1 Reply

  • Deshi_Intel's avatar
    Deshi_Intel
    Icon for Regular Contributor rankRegular Contributor
    5 years ago

    Hi,


    FYI... Intel FPGA forum community is meant to support dev kit board developed by Intel only and not for 3rd party vendor board like this DE10-Nano board which is development by Terasic


    1. Is there any way I can connect the ethernet PHY to the FPGA using the TSE IP ?
    • I can comment TSE IP do support RGMII interface but I am not familiar with the PHY chip on DE10-nano board.
      • Feel free to contact terasic directly to check out with them
    1. Can the pins be shared between the HPS and the FPGA ?
    • No, Cyclone V SOC HPS has its own dedicated IO pins while FPGA has its own dedicated IO pins


    Thanks.


    Regards,

    dlim