Forum Discussion

Chamathka's avatar
Chamathka
Icon for New Contributor rankNew Contributor
4 years ago

FPGA

I am a beginner in FPGA programming. I wanted to blink LED on my FPGA board. Code compilation was done successfully. So, I programmed it on my DE0- Nano Altera FPGA board. But I could not see the LED...
SyafieqS's avatar
SyafieqS
Icon for Super Contributor rankSuper Contributor
4 years ago

Hi Athauda,


The question is very generic lot. Can you narrow down the issue ? Make sure the functionality is correct. Assuming code wise and functionality is simulated as expected, maybe some location assignment/pin planner for you PIO wrongly assigned? Need to double check.


  • Chamathka's avatar
    Chamathka
    Icon for New Contributor rankNew Contributor
    4 years ago

    I checked it by changing the pins as well. But no change