Forum Discussion

Chamathka's avatar
Chamathka
Icon for New Contributor rankNew Contributor
4 years ago

FPGA

I am a beginner in FPGA programming. I wanted to blink LED on my FPGA board. Code compilation was done successfully. So, I programmed it on my DE0- Nano Altera FPGA board. But I could not see the LED...
sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
4 years ago

This is a very generic description of a problem. Can you provide more detail? Did you make I/O pin assignments to connect the outputs of your design to LEDs on the board? Can you provide the HDL code?