Forum Discussion

clinton_1966's avatar
clinton_1966
Icon for New Contributor rankNew Contributor
11 months ago

FPGA cyclone iv gx Transceivers power pin

my project now use cyclone IV GX150 ,then we not use Transceivers module, if we must connect VCCL_GXB, VCCH_GXB and VCCA_GXB to 2.5V power? May we let thest power pin floating? waiting your replay , thanks!!

Other Ips

1 Reply

  • WZ2's avatar
    WZ2
    Icon for Frequent Contributor rankFrequent Contributor
    11 months ago

    Hi there,

    For VCCL_GXB, should tie to 1.2V. And all these power still should be connected even if u will not use transceiver. Due to the configuration may failed if u don't connect it and have bad influence for calibration. But the power rail will not cause power waste.

    Best regards,

    WZ