Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorFlex10K and EPC2 configuration Error - Flex10K in continuous Configuration loop.
Hi All, I am new to Altera. I have a board with Flex10k30 and an EPC2 to configure it. I also have a DSP (ASDP21060) on the board which uses Flex 10k. I have recently run into an error in...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- I could not reply earlier. I will go through your schematic and update my config. --- Quote End --- Ok. --- Quote Start --- I will get back if I get into some trouble again.... --- Quote End --- Sure, I'll respond if I see a response on this thread. Cheers, Dave
