Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Flash memory to configure the Cyclone III

Hi, I am trying to use a standard flash to configure a CIII chip which is supported in the datasheet. I was wondering if anybody knows the difference between top parameter and bottom parameter...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Bah. I had an old handbook and didn't realize a new one was out. The new handbook has a section which shows how the Cyclone III skips the starting addresses ignoring the top bottom parameter issue. So its ok to use either top or bottom parameter flash chips.

  • Subhani1's avatar
    Subhani1
    Icon for New Contributor rankNew Contributor
    5 years ago

    the above you mentioned part is also obsolete plz provide any alternate part which support ap configuration.