Altera_ForumHonored Contributor15 years agoFlash generated using sof2flash fails to configure fpga Hi , I have Stratix IV development kit , I want to load Flash file converted using sof2flash utility. when i use nios2-flash-programmer it works fine . but it fails to configure FPGA fro...Show More
Altera_ForumHonored Contributor15 years agoThanks Ton . Its better idea to make thread on NIOS forum .
Recent DiscussionsRegarding Power-Up Sequence for Agilex 5Cyclone V SoC 5CSXC6 Series GXB Utilization and LimitationsHow to tell Quartus my Arria10 target system CLKUSR frequency is 100MHz?Agilex 3 PLL in Source Synchronous mode ?writing a word to cfm1 using on chip flash ip on max10