Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Failed to start the software

Hi all, After install the cyclone III, I get the message below: Could not establish JTAG connection between the board and control panel application. Please ensure the board is configured w...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

--- Quote Start ---

did you try the 10.1 installer for the development kit? its on the products page

--- Quote End ---

Yes, we used 10.1 for quartus, 10.1 for the NiosII EDE, and 10.1 for the development kit.

Link to the kit:

www dot altera dot com /products/devkits/altera/kit-cyc3-starter.html

Link to 10.1 installer we used:

ftp dot altera dot com /outgoing/devkit/10.1/cycloneIII_3c25_start_v10.1.0.exe