Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Failed to start the software

Hi all, After install the cyclone III, I get the message below: Could not establish JTAG connection between the board and control panel application. Please ensure the board is configured w...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Have the same problem. New Cyclone III 3C25 evaluation kit, but when I try to start Board Test System I get a message "Could not establish JTAG connection between the board and control panel"

I tried reprogramming the FPGA with the .sof-file provided in the Starter kit, but this did not help.

Any suggestions?