Error: Can't assign I/O pad "p2_rx0_in(n)" to PIN_AV44 because this causes failure in

Question

Hi,

I'm using Altera's PHY (transiver only) for PCI express gen1 in Stratix 4 device(530 DEVICE).

I want to make use of one transiver block to make a different ports (x1 link).

When I use a different quad(transiver block) in pin assignment I can get the design working but I don't want that. I want to use a same quad's different channel for different ports.

Please suggest...

Thanks...

altera_forum · Answer

There's some help available for the error text in the Altera knowledge base. You should always try it first.  http://www.altera.com/support/kdb/solutions/rd01182012_335.html

Forum Discussion

Error: Can't assign I/O pad "p2_rx0_in(n)" to PIN_AV44 because this causes failure in

1 Reply

Recent Discussions

Worst-Case Completion Time for PLL Dynamic Phase Shift (PHASESTEP → PHASEDONE)

Agilex 7 DDR4 Reset and ADDR/CMD Clock PCB Implementation Documentation Discrepancy

Cyclone 5 SoC FPGA Bank Supply Prerequisite

carry chain tdc

Agilex 7 Decoupling capacitor scaling factor