Forum Discussion

BenBeauchamp's avatar
BenBeauchamp
Icon for New Contributor rankNew Contributor
5 years ago

EPF10K100A

I have a question about an old Altera PLD that I have in one of my designs. My design currently has an EPF10K100A PLD in the 240 pin RQFP package. Do I need to recompile my code and generate a new programming file if I want to change to the EPF10K100A PLD in the 484 pin FBGA package? I understand that I would need to map the I/O from the 240 pin RQFP to the 484 pin FBGA device on my board. As long as I correctly map the I/O, can I reuse the same programming file? If both parts leverage the same die, but are just bonded out differently depending on the package, I would think that this should work. Any feedback would be greatly appreciated.

Thanks,

Benjamin Beauchamp

2 Replies

  • Ash_R_Intel's avatar
    Ash_R_Intel
    Icon for Regular Contributor rankRegular Contributor
    4 years ago

    We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you