Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

EPCQ replacing EPCS128

I use a Arria V with an EPCS128. When I replaced it with an (Altera) EPCQ128A, it programs/verifies fine (.jic using 13.1 programmer) but the Arria won't start (flash won't load?) when I power-cycle....
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Anand,

Thank you for your reply. Before I begin following the steps, I just wanted you to know I have been following tomatoma on a very similar issue. In a May18 3:10pm post, he was able to make his board functional by adding capacitance to the data lines. And he mentioned a roadblock with .pof vs. .sof vs. jic when following an822. I'll keep you posted.