Forum Discussion

sittinhawk's avatar
sittinhawk
Icon for New Contributor rankNew Contributor
2 months ago

DK-DEV-AGI027-RA QSPI Verification Fails

I'm using the DK-DEV-AGI027-RA, and I have successfully programming the QSPI flash once and this was successfully and I am able to auto-boot on powerup. However, now when I try to program a new load...
Configuration
sittinhawk's avatar
sittinhawk
Icon for New Contributor rankNew Contributor
2 months ago

I tried using JTAG mode, but I'm still getting verify failed on the QSPI flash. Are there any official instructions for building and programming QSPI for this specific board?

JohnT_Altera's avatar
JohnT_Altera
Icon for Regular Contributor rankRegular Contributor
2 months ago

Hi,

 

May I know if the programming work after power cycle if the verify is not being performed? May I know what is the TCK freq used?