Forum Discussion

Lnguyen's avatar
Lnguyen
Icon for New Contributor rankNew Contributor
4 years ago

Device Configuration for Cyclone 10GX

Hello, I'm new to Intel FPGA, Cyclone 10 GX. I would like to use QSPI device for FPGA configuration. The Intel documents give supported devices as EPCQxxx (where xxx is 032, 064, 128, 256, or 512Mb...
NurAiman_M_Intel's avatar
NurAiman_M_Intel
Icon for Super Contributor rankSuper Contributor
4 years ago

Hi,


Thank you for contacting Intel community.


You may option to replace EPCQ with other configuration device such as EPCQ-A, Micron, etc.. depending on your needs. Kindly refer to below page:


https://www.intel.com/content/www/us/en/products/programmable/configuration-device.html


https://www.intel.com/content/www/us/en/programmable/support/support-resources/support-centers/configuration-support.html#intel-config-devices


https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/component/2018/how-do-i-enable-micron-s-mt25q-support-for-eol-of-epcq---256mb--.html


Let me know if you need further information.


Regards,

Aiman