Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
19 years ago

Default drive strengths for Stratix III and Cyclone III

Note that Stratix III and Cyclone III default drive strengths on most I/O standards are set to OCT Rs for better signal integrity. On previous families they were set to max drive strength for best pe...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
19 years ago

Signal integrity problems are very difficult to debug. A "likely to work" scenario is a little scary. I have started using signal integrity analysis tools like hyperlynx and this has helped me to discover potential problems in advance. This way I can tune my drive strength based on my board abd IO characteristics.

Have you looked at tools like this to decide the best drive strength to use?

FPGA Guy