Forum Discussion
YigalB1
New Contributor
New ContributorDE10 Lite setting pins from VErilog RTL
In my design, the GPIOs need to be used to connect to external host (Raspberry PI (aka RPI) in this case). The GPIOs connector of the DE10 lite will be connected to the RPI connector. Some are inp...
Just edit the top-level. And you need to give unique names to inputs vs. outputs (GPIO_IN vs. GPIO_OUT perhaps).
RichardT_altera
Super Contributor
Super ContributorI believe all your inquiries has been answered.
Do you have any further question?
Regards,
Richard Tan
YigalB1New Contributor
New ContributorI think I am all set. Thank you for the good support.
