Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Cyclone V E Development Kit failed on Active Serial Configuration via JTAG

Hi All, I am currently working on Cyclone V E Development Kit. I tried to save configuration file into EPCQ256SI16N. I did follow the youtube https://www.youtube.com/watch?v=dpsfcgnqocu to gener...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

--- Quote Start ---

Hi,

Make sure the jumpers shown below are configured in the factory default settings:

https://www.alteraforum.com/forum/attachment.php?attachmentid=14406

https://www.alteraforum.com/forum/attachment.php?attachmentid=14407

https://www.alteraforum.com/forum/attachment.php?attachmentid=14408

https://www.alteraforum.com/forum/attachment.php?attachmentid=14409

Put these DIP switches in the factory defaults as shown above and then try configuring the FPGA. It should work.

--- Quote End ---

Follow the reference manual for development board kit, the factory default setting is for FPP Configuration, it's not for AS configuration. I have tried all combination of MSEL[4-0], it doesn't work for any combination setting.