Forum Discussion

Honored Contributor

11 years ago

Cyclone V DDR3 termination resistor

Hello, I am currently working on the design of a Cyclone V SE board with 2 DDR3 memory chips. I am wondering if it is necessary to have the termination resistors for the adress / command sign...

Altera_Forum

Honored Contributor

11 years ago

I don't know the answer to that question but it's probably in this document: http://www.altera.com/literature/an/an520.pdf

I found that on the board design guidelines page here: http://www.altera.com/technology/signal/board-design-guidelines/sgl-bdg-index.html

Forum Discussion

Cyclone V DDR3 termination resistor

Recent Discussions

Cyclone 10 LP's Extended Industrial parts

Bidirectional pin USB_RX with a pseudo-differential I/O standard must use the OEIN port of the node

Obsolescence issues

Avalon-ST configuration with Agilex 3 fails

Cyclone IV E – PLL Power Track Width Recommendation Clarification