Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorCyclone V ASx4 configuration
I've got a Terasic Cyclone V GX development board. I removed the EPCQ256 configuration device and am testing another alternative (Micron MT25QL256ABA). I created a simple project with LEDS and "generic_quad_spi_controlelr2" and am using JTAG indirect programming to program the device (jic file).
Quartus (17.1) will program the device without error. When I created the jic in "Active serial" mode it is able to boot but in "Active Serial x4" it isn't. Any thoughts?1 Reply
Altera_ForumHi,
Although you are using the Quartus Prime software version 17.1, Can you check once by setting the non-volatile configuration register from the following link for ASx4? https://www.altera.com/support/support-resources/knowledge-base/component/2018/how-do-i-enable-micron-s-mt25q-support-for-eol-of-epcq---256mb--.html?cq_ck=1522223941654 Let me know if this has helped resolve the issue you are facing or if you need any further assistance. Best Regards Vikas Jathar Intel Customer Support – Engineering (Under Contract to Intel)
