Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorCyclone-IV E USB Blaster JTAG header VCC(TRGT)
Dear sir, I am using cyclone -IV E FPGA in JTAG chain. I don't have free pins on JTAG header on the board to connect, 2.5V to pin number 4 of USB blaster cable. Can I connect 3.3V to pin ...
Altera_ForumHonored Contributor
Honored ContributorRefer to the 'JTAG Configuration' section of:
http://www.altera.com/literature/hb/cyclone-iv/cyiv-51008.pdf (http://www.altera.com/literature/hb/cyclone-iv/cyiv-51008.pdf) For VCCIO voltages of 2.5V and above, the USB-Blaster must be powered by VCCA - 2.5V (figure 8-23). For VCCIO voltages below 2.5V the USB-Blaster is powered by the VCCIO voltage (figure 8-24).
