Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Cyclone IV E, transferring data using serial port

Hello everyone, In a nutshell I have the following FPGA: http://fpga.redliquid.pl/images/ep4ce6/1.jpg (FPGA Cyclone IV E, ECP4E6), and what I want to do is to use the serial port. I've b...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hi,

Your board does not have a USB interface/connector.

You can use Hyperterminal and a serial port(RS232) on your board and establish the serial communication.

Use Nios ii processor, on-chip memory, jtag Uart & uart(rs232 serial port) for qsys design.

For more information refer to link below.

http://my-fpga.blogspot.my/2011/02/using-rs232-on-niosii-processor.html

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)
MRP's avatar
MRP
Icon for New Contributor rankNew Contributor
4 years ago

Dear Anand Raj Shankar

I am using CoreEP4CE6, Altera Core Board for my lab work. I am also trying to communicate with MATLAB through UART. So for configuration, can I use the same procedure shown in the following link http://my-fpga.blogspot.my/2011/02/using-rs232-on-niosii-processor.html .

I am very new to FPGA hardware and my background also does not match with electronics. Help me to configure my FPGA to communicate with MATLAB via UART.

Best regrads

MRP