Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Cyclone IV E, transferring data using serial port

Hello everyone, In a nutshell I have the following FPGA: http://fpga.redliquid.pl/images/ep4ce6/1.jpg (FPGA Cyclone IV E, ECP4E6), and what I want to do is to use the serial port. I've b...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hi,

Go through some basic training.

https://www.altera.com/support/training/curricula.html

Refer following Links.

https://www.youtube.com/watch?v=nhfvwthr_ew

https://www.youtube.com/watch?v=yetvltb4hm4

First, understand you board specification.

Do you have onboard SDRAM, You can use on-chip ram instead of using SDRAM to avoid extra pin assignment work.

To eliminate the error.

Auto-assign the base address and interrupt from a system option from tools bar of qsys.

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)