Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

CYCLONE III can't CONFIGURE !...

Hi Everybody, We use Cyclone III (EP3C25E144C8N) fpga in our project. We use EPCS16 for serial programmer. Problem is, fpga cannot finish the configuration. I watched the signals with a lo...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Is this waveform your first cycle?

Usually EPCS being asked report status after erase or write as I understand.