Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
19 years ago

Cyclone II PS configuration problem

Hi all, I am trying to configure 3 EP2C20 with 3 EPC2 device. The EPC2 device was configured with JTAG. So when the board power up the EP2C20 should be configured by the EPC2. The connec...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
19 years ago

Please see attached file.

all FPGAs/EPROM are connected this way, except for FPGA# 1 takes the CONF_DONE and nSTATUS of the other two device as inputs and has an single output of CONF_DONE to an LED.

What else is wrong? I am very frustrated.

Thanks in advance for any idea. :)