Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
19 years ago

Cyclone II - losing configuration after power off

Hi. I programe FPGA through JTAG (MSEL0, MSEL, nCE, DCLK0->GND; nCONFIG->VCC; nSTATUS, CONFIG_DONE->VCC through resistor). I'm using QuartusII (Device & Pin Options: Configuration scheme: PS - I c...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
19 years ago

Hi.

I'm just getting started withe FPGAs, so that is why I ask silly questions.

I was sure, that what you loaded to FPGA is held. On other board with MAXII loaded configuration is held even if I turn the power off. And there is no prom on any of these two boards.

Thank You for your answers