Forum Discussion

ivar_svendsen's avatar
ivar_svendsen
Icon for New Contributor rankNew Contributor
3 years ago

Cyclone 10LP Power requirements

Hello, I am planning to use Cyclone 10LP (F484 BGA) with a 3.3V Active Serial configuration scheme. All Active Serial configuration pins are part of Bank 1. I hope to be able to use banks 5, 6 and ...
Configuration
Power
ivar_svendsen's avatar
ivar_svendsen
Icon for New Contributor rankNew Contributor
3 years ago

Hello,

I guess I need to make a board and try. It is still not very clear.

The device datasheet lists 5 recommended operation voltage ranges (1.2V up to 3.3V), but there is no information on how the chip decide which range the power supply must be stable within, before the end of POR (nSTATUS is released).

There are also no information to what constitute "without plateau".

Regards,

Ivar Svendsen.