Forum Discussion

ChathEsh's avatar
ChathEsh
Icon for New Contributor rankNew Contributor
2 years ago

Cyclone 10 LP VccIO

I have a Cyclone 10 LP based design where VccIO of one of the IO banks is being supplied by a 3.3V, but the output pins are configured as 1.8V. This is caused by use of same firmware in different har...
Configuration
Generic Io
NazrulNaim_Intel's avatar
NazrulNaim_Intel
Icon for Regular Contributor rankRegular Contributor
2 years ago

Hello,


I'm agree with the answer provided from user 'FvM", but based on the official document, it is not recommended to use the connection like this, but it is not restricted. This is because based on the official documentation, the NC pin should not be connected. More information regarding on the connection guideline can be accessed through the link below.


Link : https://cdrdv2.intel.com/v1/dl/getContent/670726?fileName=pcg-01021-683137-670726.pdf


Hope that answers your question.


Best regards,

Nazrul Naim