Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

custom peripheral

Hi,

I am new in FPGA things. I try to make a custom peripheral in my new project (using EP2S60). This peripheral will receive instruction from NIOS and can read and write to SRAM. I read in the handbook that i need to make one avalon slave port to connect with the NIOS and make one avalon master port to connect to the SRAM.

Is it correct? since my design did not work at all and i got so many error message.

thanks,

Tantan

3 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    18 years ago

    Hello tantan

    You should try this question in the Nios forum, it fits there better.

    -Joe D
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    18 years ago

    i already put there under my previous post (how to make custom peripheral). Maybe it is better if i re-post in the new topic. Until now, noone answer yet.

    Thanks
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    18 years ago

    Tantan,

    Please do no duplicate posts in multiple categories/forums. This is bad etiquette in discussion board communities. I will have to delete posts if they are duplicated by single user in multiple categories/forums.

    thanks