Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Configuring 2 Cyclone III's from one EPCS16 Using 2.5V

Hello, My FPGA configuration signals an error by pulling the nStatus line down at the end of configuration and starting over (and over and over). 1. I am attempting to configure two EP3C4...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

--- Quote Start ---

I am using the standard 10 pin AS Header for programming the EPCS.

--- Quote End ---

Send me an email (to my forum name) and I'll send you an application that can read/write the EPCS.

Cheers,

Dave