Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

clock requirement, again

I had posted this question previous but received no satisfactory answer. I have a FPGA starter training board. I have been designing some sequential circuits using the TTL macrofunctions and conventi...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Check your board specs. Probably on the altera's site you would find the file with the pins positions. Download it and import it in your project. The read the board manual. It will tell you which pin is the clock, if it has one.