Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

altremote_update - application image mode

Hi, I know there are plenty of threads on this subject, I did read them but I am still confuse. I am using a Cyclone III EP3C10F256C8 FPGA and ECPS16. My intention is to upload the firmwa...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

--- Quote Start ---

Did you try with 0x20000? This is the way I do it in my Cyclone IV project and that seem to work. I thought all addresses was byte addressing.

--- Quote End ---

A billion thanks! It works! (previously when I tried and replied I did something wrong).

I start getting non-technical skepticism when using Altera after such negative experiences with conflicting userguides/application notes...

The AN521 clearly says it should be the word addressing without the last 2 lsbs :mad::confused:

... from now on every time I have an error I will tend to first blame Altera :-P

Thanks again!